Chris Chamberlain (cchamber@oakland.edu)
Wed, 16 Jun 1999 15:19:18 -0400 (EDT)
I am trying to upgrade to RH6.0 from 5.2 and when it gets to the part
where it asks for SCSI devices, I say yes and pick the Iomega Parallel
port driver, and autoprobe. The install comes back and says it can't find
the drive? This worked just fine in RH5.2 install. Has anyone here seen
this problem, and if so how to fix it?
ps. i have also tried specifying the options i.e.
ppa=0x378,speed_high,speed_low,nybble. This gives the same error as
above.
Thanks,
Chris Chamberlain
email: cchamber@oakland.edu
----------------------------------
Through the modem, off the server,
over the T1, past the frame-relay,
< < NOTHIN' BUT NET > >
----------------------------------
-- To unsubscribe, send mail to: linux-parport-request@torque.net --
-- with the single word "unsubscribe" in the body of the message. --
This archive was generated by hypermail 2.0b3 on Wed 16 Jun 1999 - 15:20:24 EDT