What are you trying to do with "cat"? I see the same results but I can use
it in a program fine. Are you writing a program? I don't know what you are
trying to accomplish...
Nate
----- Original Message -----
From: "Gunther Mayer" <Gunther.Mayer@t-online.de>
To: "Chris Shaw" <chriss@watertech.com>
Cc: <linux-parport@torque.net>
Sent: Wednesday, December 04, 2002 8:24 AM
Subject: Re: [PARPORT] SuperIO Support
> Chris Shaw wrote:
> >
> > I was just wondering which SuperIO Chipsets the current parport code
> > supports. I have a GigaByte board which uses an ITE IT8705F SuperIO.
>
> When I load parport_pc, everything seems fine, the IO/IRQ/DMA and
> > settings are detected but no data will come through the port. When I do
a:
> >
> > # cat /dev/lp0 (After loading lp.o of course :) )
> >
> > I get:
> >
> > lp0: Input/Output Error...
> >
> > I'm not sure how to correct this, I have tried putting it in all modes
> > (Polling/Interrupt/Software) but nothing seems to work...
>
> You missed
> insmod lp
>
> -- To unsubscribe, send mail to: linux-parport-request@torque.net --
> -- with the single word "unsubscribe" in the body of the message. --
>
>
-- To unsubscribe, send mail to: linux-parport-request@torque.net --
-- with the single word "unsubscribe" in the body of the message. --
This archive was generated by hypermail 2b29 : Wed Dec 04 2002 - 11:26:57 EST